6.1 FlexiBridge function
The flexible induction cooking area consists
of four sections. The sections can be
combined into two cooking zones with
different size, or into one large cooking area.
You choose the combination of the sections
by choosing the mode applicable to the size
of the cookware you want to use. There are
three modes: Standard (activated
automatically when you activate the hob), Big
Bridge and Max Bridge.
To set the heat setting use two
left side control bars.
Switching between the modes
To switch between the modes use sensor
field:
.
When you switch between the
modes the heat setting is set
back to 0.
Diameter and position of the cookware
Choose the mode applicable to the size and
the shape of the cookware. The cookware
should cover the selected area as much as
possible. Place the cookware centrally on the
selected area!
Place the cookware with the bottom diameter
smaller than 160 mm centrally on a single
section.
Place the cookware with the bottom diameter
larger then 160 mm centrally between two
sections.
6.2 FlexiBridge Standard mode
This mode is active when you activate the
hob. It connects the sections into two
separate cooking zones. You can set the
heat setting for each zone separately. Use
two left side control bars.
Correct cookware position:
14 ENGLISH
To Next Page
Loading...
