5.1 Display
The display shows the following informa-
tion:
Duration of the set programme
When you set a programme, the display shows the duration in
hours and minutes (for example 2.05).
The duration is calculated automatically on the maximum load
for each type of fabric.
After the programme has started, the time remaining is updated
every minute.
Alarm codes
In the event of operating problems, some alarm codes can be
displayed, for example
(see chapter «Troubleshooting»).
End of programme
When the programme has finished, the display shows a blinking
zero
.
The DOOR light B, the WASHING light A and the light of button
8 go out.
The door can be opened.
Incorrect option selection
If you set an option which is not compatible with the wash pro-
gramme, the display shows the message Err for some seconds.
The yellow pilot light of button 8 light starts blinking.
Delay Start
When you press the relevant button to set the delay (20 hours
max), it appears for some seconds, then the display shows the
duration of the set programme.
The delay time value decreases by one unit every hour. When
only 1 hour remains, the time decreases every minute.
Delay Start symbol
This symbol comes on when you set the delay time.
Child safety lock
This symbol comes on when you activate the child lock function.
8
www.aeg.com
To Next Page
Loading...
Need help?
General
