4. Make sure to identify the different
sizes and the positions of the sound
barriers. Refer to the illustration:
• A (FRONT) = Front of the
appliance
• B (BACK) = Rear of the appliance
5. Remove the adhesive strip from the
sound barriers and attach the four
barriers to bottom of the appliance.
Make sure that the barriers are
securely attached.
Attach the sound barriers at
a room temperature.
6. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holders.
It is possible to see water
flowing from the drain hose.
This is due to the testing the
appliance with water in
factory.
7. Remove the three transit bolts and
pull out the plastic spacers.
We recommend that you
keep the packaging and
the transit bolts for any
transport of the appliance.
8. Put the plastic caps, that you find in
the user manual bag, in the holes.
5.2 Installation on suspended
flooring
Suspended wooden floors are
particularly susceptible to vibration.
To limit vibration we recommend placing
a waterproof wooden panel, at least 15
mm thick, under the appliance. It should
be screwed to at least 2 floor beams and
should extend beyond the front feet.
If possible, install the appliance where
the floor is more stable.
5.3 Positioning and levelling
1. Install the appliance on a flat hard
floor.
ENGLISH 9
To Next Page
Loading...
Need help?
General
