If the tanks are filled before
the appliance is powered on
for the first time, the
AutoDose indicator will not
blink.
CAUTION!
The tanks refill must be
carries out with the same
brand and type of detergent/
fabric softener/additive used
before, otherwise clean the
tanks before refilling.
9.7 Switching from AutoDose
to manual dosing
It is possible to disable AutoDose
function for one or both tanks by
pressing related button symbol.
Example:
• To switch Fabric Softener tank off,
press the Softener
button until the
display shows OFF.
• If you need to use different detergent
than ones present in AutoDose tanks,
you could switch Detergent tank off by
pressing the Detergent button
until the display shows OFF.
9.8 Deactivating the
AutoDose
If you prefer to use the compartments for
manual filling as default choice, you can
deactivated the AutoDose tanks
completely.
Once you have entered the AutoDose
configuration mode by pressing Temp.
°C and the Centrif. buttons:
1. Tap on the Detergent button or
the Softener button until display
shows
: the AutoDose is
excluded completely for related tank
or both.
2. After about 10 seconds the display
returns to the programme information
screen.
9.9 Manual filling the
detergent and additives
You may need to use a different
detergent or fabric softener than the
ones used in the AutoDose tanks. First,
make sure that the AutoDose tanks are
disabled and then pour the detergent
and/or other treatments in the manual
compartments.
Do not exceed the maximum
indicated level ( ).
1. Open the detergent dispenser.
2. Put the powder detergent in the
compartment . When using liquid
ENGLISH 27
To Next Page
Loading...
Need help?
General
