The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The indicator is on display. The door
stays locked and the drum turns regularly
to reduce creasing. You must drain the
water to unlock the door.
If you touch the Start / Pause button,
the appliance performs the spinning phase
and drains the water.
The appliance empties the water out
automatically after 18 hours
approximately.
7.5 Wash Mode
This button allows to activate or deactivate
the washing mode. When the washing mode
is activated, the button indicator is on.
7.6 Prewash
With this option you can add a prewash
phase to a washing programme.
The corresponding indicator above the touch
button illuminates.
Use this option to add a pre-wash phase at
30 °C before the washing phase.
This option is recommended for heavily soiled
laundry, especially if containing sand, dust,
mud and other solid particles.
The option can increase the programme
duration.
7.7 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
To activate/deactivate this option, hold the
Prewash button pressed for 3 seconds until
the indicator comes on/goes off on the
display.
When it is activated, the appliance will default
to this option after you switch it off or change/
reset the programme.
This option increases the programme
duration.
7.8 Stains
Touch this button to add the stain phase to a
programme.
The corresponding indicator above the touch
button illuminates.
Use this option for laundry with hard stains to
remove.
When you set this option, put the stain
remover into compartment
.
This option increases the programme
duration.
This option is not available with a
temperature lower than 40 °C.
7.9 Permanent Soft Plus
Set this option to optimise the fabric softener
distribution and improve fabric softness.
Recommended when you use fabric softener.
To activate/deactivate this option , hold the
Stains button pressed for 3 seconds until the
indicator comes on/goes off on the
display.
When it is activated, the appliance will default
to this option after you switch it off or change/
reset the programme.
This option increases the programme
duration.
Time Save
With this option you can reduce the
programme duration depending on the load
size and the degree of soiling.
When you set a washing programme, the
display shows the default duration and
dashes.
ENGLISH 23
To Next Page
Loading...
Need help?
General
