2. Open the appliance door. If necessary,
add or remove the items. Close the door
and touch the Start / Pause button.
The programme or the delay start continues.
11.12 End of the programme
When the programme has finished, the
appliance stops automatically. The acoustic
signals operate (if they are active). The
display shows
The indicator of the Start / Pause button
goes off.
The door unlocks and the indicator goes
off.
1. Press button On/Off to deactivate the
appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the appliance again,
the display shows the end of the previous
programme. Turn the programme dial to
set a new cycle.
2. Remove the laundry from the appliance.
3. Make sure that the drum is empty.
4. Keep the door and the detergent
dispenser slightly ajar to prevent mildew
and odours.
11.13 Draining water out after end
of cycle
If you have chosen a programme or an option
that does not empty out the water of the last
rinse, the programme is completed, but:
• The time area shows and the
display shows the door locked .
• The indicator of the Start / Pause
button starts flashing.
• The drum still turns at regular intervals to
prevent creases in the laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed by the
appliance.
2. Press the Start / Pause button: the
appliance drains the water and spins.
The option indicator Rinse Hold
disappears.
If you have selected No Spin , the
appliance will only drain the water.
3. When the programme is completed and
the door locked indicator goes off,
you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
11.14 Stand-by function
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:
• You do not use the appliance for 5
minutes when no programme is running.
Press the button On/Off to activate the
appliance again.
• 5 minutes after the end of the washing
programme.
Press the On/Off button to activate the
appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
cycle.
If the dial is rotated to the "Reset" position ,
the appliance automatically turns off in 30
seconds.
If you set a programme or an option that
ends with water in the drum, the Stand-
by function doesn't deactivate the
appliance to remind you to drain the
water.
ENGLISH 37
To Next Page
Loading...
