AEG LFR61944AD - Page 33

11.1 QR code on rating plate
00000000
00A
Mod.
xxxxxxxxx
000V ~ 00Hz 0000 W
910000000
00
Prod.No.
SCANNING...
QR code can be used in two ways:
• Scan the QR code with the built-in
camera app to download the My AEG
Care application from the App store
on your smart device and follow the
required steps.
• Pairing your smart device with
appliance to simplify the process.
Scan the QR code with QR code
scanner built-in My AEG Care
application.
11.2 Installing and
configuring My AEG Care
My AEG Care allows you to
control your laundry through
a mobile device.
It contains a large number of
programmes, useful features
and product information
tailored perfectly to the
appliance.
Through the app you can
select the programmes
already available from the
appliance control panel, plus
unlock additional
programmes available only
from a mobile device.
Additional programmes can
change over the time along
with new versions of the
app.
It's personalized laundry
care - all from your mobile
device.
When connecting the appliance to the
application, stand near it with your smart
device.
Make sure that your smart device is
connected to the wireless network.
1. Go to the App Store on your smart
device or scan QR code ( see 'QR
code on rating plate' paragraph ).
2. Download and install the My AEG
Care App.
3. Make sure you started a Wi-fi
connection in the appliance. If not,
read the next paragraph 'Configuring
the appliance wireless connection'.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in My
AEG Care.
5. Follow the instructions on the App for
the appliance registration and
configuration.
11.3 Configuring the washing
machine wireless connection
1. Press and hold the On/Off button for
a few seconds to activate the
appliance. Wait about 10 seconds
before proceeding with wireless
configuration.
2. Press and hold the
and the
buttons for a few seconds
simultaneously until a 'click' sounds.
Release the buttons. appears on
the display for 5 seconds and the
indicator starts blinking.
The wireless module begins starting up.
Make sure that you APP is
ready for connection.
3. After about 45 seconds,
(Access Point) appears on the
display.
ENGLISH 33