Temp. °C
touch but‐
ton
When you select a washing programme, the appliance automatically
proposes a default temperature.
Touch this button repeatedly until the desired temperature value ap‐
pears on the display.
When the display shows the indicators and , the appliance
does not heat the water.
On/Off
push but‐
ton
Pressing this button for a few seconds allows to activate or deactivate
the appliance. Two different tunes sound while switching the appli‐
ance on or off. As the Stand-by function automatically deactivates the
appliance to decrease the energy consumption in a few cases, you
may need to activate the appliance again.
Refer to "Stand-by option" paragraph in "Daily Use"
chapter for more details.
Permanent Extra
Rinse
With this option you can permanently have an extra rinse.
To activate/deactivate this option touch the Opc. button, the relevant
indicator comes on/goes off over rinse phase symbol.
This option adds two rinses.
Child Lock
With this option you can prevent that the children play with the control
panel.
To activate/deactivate this option, touch the Lav.Intenso/Pre-Lav.
button until the indicator comes on/goes off on the display.
You can activate this option:
• After you touch the Inicio/Pausa button: all the buttons and the
programme dial are deactivated (except On/Off button).
• Before you touch the Inicio/Pausa button: the appliance cannot
start.
The appliance keeps the selection of this option after you switch it off.
Acoustic signals
This appliance is provided with different acoustic signals, that operate
when:
• You activate the appliance (special short tune).
• You deactivate the appliance (special short tune).
• You touch the buttons (click sound).
• You make a wrong selection (3 short sounds).
• The programme is completed (sequence of sounds for about 2 mi‐
nutes).
• The appliance has a malfunction (sequence of short sounds for
about 5 minutes).
To deactivate/activate the acoustic signals when the programme is
completed, touch the Lav.Intenso/Pre-Lav. and the Inicio Diferido but‐
tons simultaneously for about 6 seconds.
If you deactivate the acoustic signals, they continue
operate when the appliance has a malfunction.
www.aeg.com18
To Next Page
Loading...
Need help?
General
