WARNING!
It is possible to see water flowing
from the drain hose. This is because
the washing machine has been
tested at the factory.
4. Remove the three bolts by using the key
supplied with the appliance. Pull out the
plastic spacers.
We recommend that you keep the
packaging and the transit bolts for any
transport of the appliance.
5. Put the plastic caps, that you find in the
user manual bag, in the holes.
5.2 Positioning and levelling
1. Install the appliance on a flat hard floor.
Make sure that carpets do not stop the
air circulation below the appliance.
Make sure that the appliance does not
touch the wall or other units.
2. Loosen or tighten the feet to adjust the
level.
WARNING!
Do not put cardboard, wood or equivalent
materials below the appliance feet to
adjust the level.
The appliance must be level and stable.
A correct adjustment of the appliance
level prevents the vibration, noise and
the movement of the appliance when in
operation.
When the appliance is installed on a
plinth or a tumble dryer is stacked on the
washing machine, use the accessories
described in chapter 'Accessories'. Read
carefully the instructions supplied with
the appliance and with the accessory.
5.3 The inlet hose
1. Connect the water inlet hose to the back
of the appliance.
2. Position it toward left or right depending
on the position of the water tap.
ENGLISH 9
To Next Page
Loading...
