AEG LP7250 - Page 28

7.
2
1
8.
2
1
1
WARNING!
Make sure that the impeller of the pump can rotate. If it does not rotate,
contact the Authorised Service Centre. Make sure also that you tighten
the filter correctly to prevent leakages.
13.8 Cleaning the inlet hose and the valve filter
1
2
3
45°
20°
13.9 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph.
If necessary, clean the pump.
13.10 Frost precautions
If the appliance is installed in an area
where the temperature can reach values
around 0° C or drop below, remove the
remaining water from the inlet hose and
the drain pump.
www.aeg.com28