The relevant indicator goes on in the display.
• Taches
Select this option to add an anti-stain
phase to a programme in order to treat
heavily soiled or stained laundry with stain
remover.
Pour the stain remover into compartment
. The stain remover will be added in
the appropriate phase of the washing
programme.
This option can increase the
programme duration and is not
available with a temperature lower
than 40 °C.
• Prélavage
Use this option to add a prewash phase at
30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust , mud and other solid particles.
This option can increase the
programme duration.
9.8 Rinçage Plus
With this option you can add up to 3 rinses
accordingly to the selected washing
programmes.
Useful for people allergic to detergents and in
areas where the water is soft.
The indicator shows the selected number
of rinses.
This option increases the programme
duration.
If the Rinçage Plus is set as a default
option and you select a compatible
washing programme, the display shows
. In this case, by pressing the Rinçage
Plus button , it is possible to add just one
rinse.
9.9 Skipping phase button (Option)
By touching this button you can set:
• Rinçage option. The appliance performs
only the rinsing phase , the spinning and
the draining phases of the selected
programme.
• Essorage option. The appliance performs
only the spinning phase of the selected
washing programme.
• Vidange option. The appliance performs
the only draining phase of the selected
washing programme.
At firth touch the appliance proposes the
default setting of the washing programme
again.
9.10 Vapeur Plus
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme. The steam phase
reduces fabric creasing and facilitates the
fabric ironing.
The indicator flashes on the display during
steam phase.
The drum performs smooth movements for
about 30 minutes. The duration of the steam
phase changes accordingly to the selection.
When Plus Steam option is set the
programme ends up with an anticrease phase
during which the drum is occasionally rotated
to prevent wrinkling. The display shows the
indicator is steady on and the indicator
starts flashing. Départ/Pause button is lit as
well. At the end of the anticrease phase the
drum definitely stops, the indicator goes off,
the door unlocks. User at any moment can
terminate the anticrease phase by:
• pressing the Marche/Arrêt button for a few
seconds to activate or deactivate the
appliance;
• turning the selector knob to another
position.
A small laundry load helps to reach better
results.
ENGLISH 19
To Next Page
Loading...
Need help?
General
