12.4 Liquid or powder detergent
• Position A for powder detergent (factory
setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid
detergents.
• Do not put more liquid then the
maximum level.
• Do not set the delay start function.
12.5 Setting a programme
1. Turn the programme knob. The related
programme indicator comes on.
The indicator of button Départ/Pause flashes
with red colour.
The display shows the default temperature,
the spin speed and the empty indicator bars
of the available functions.
2. To change the temperature and/or the
spin speed, press the related buttons.
3. Set the available functions.
12.6 Starting a programme without
the delay start
Press button Départ/Pause to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase is
operation starts to flash.
The programme starts, the lid is locked. The
display show the indicator .
The drain pump can operate for a short
time when the appliance fills water.
12.7 Cycle time recalculation
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the cycle time to the laundry you have
put in the drum to have perfect
washing results in the minimum
necessary time.
• The display shows the new time
value.
12.8 Starting a programme with the
delay start
1. Press button Départ Différé again and
again until the display shows the number
of minutes or hours of delay.
The related indicator comes on.
2. Press button Départ/Pause.
ENGLISH 23
To Next Page
Loading...
Need help?
General
