After each cycle, keep the door and the
detergent dispenser slightly ajar to get air
circulation and dry the humidity inside the
appliance: this will prevent mildew and
odours.
If the appliance is not used for a long time:
close the water tap and unplug the appliance.
Indicative periodic cleaning schedule:
Descaling Twice a year
Maintenance wash Once a month
Clean lid seal Every two months
Clean drum Every two months
Drum light Twice a year
Clean detergent dispens‐
er
Every two months
Clean drain pump filter Twice a year
Clean the inlet hose and
the valve filter
Twice a year
The following paragraphs explain how you
should clean each part.
14.2 Removing foreign objects
Make sure that pockets are empty and all
loose elements are tied up before
running your cycle. Refer to "The laundry
load" in "Hints and tips".
Remove any foreign objects (such as metal
clip, buttons, coins, etc) that you may find in
the filters and the drum. Refer to "Cleaning
the drum", "Cleaning the drain pump" and
"Cleaning the inlet hose and the valve filter"
paragraphs. If necessary, please contact the
Authorised Service Centre.
14.3 External cleaning
Clean the appliance with mild soap and warm
water only. Fully dry all the surfaces. Do not
use a scouring pads or any scratching
material.
CAUTION!
Do not use alcohol, solvents or chemical
products.
CAUTION!
Do not clean the metal surfaces with
chlorine-based detergent.
14.4 Descaling
If the water hardness in your area is high or
moderate, we recommend that you use a
water descaling product for washing
machines.
Regularly examine the drum to prevent
limescale and rust particles.
To remove rust particles use only special
products for washing machines. Do this
separately from the laundry wash.
Always obey the instructions that you find
on the packaging of the product.
14.5 Maintenance wash
With the low temperature programmes it is
possible that some detergent stays in the
drum. Perform a maintenance wash regularly.
To do this:
• Remove all laundry from the drum.
• Select the cotton programme with the
highest temperature with a small quantity
of detergent.
14.6 Lid seal
Regularly examine the seal and remove all
objects from the inner part. Clean it when
needed, using ammonia cream cleanser
agent without scratching the seal surface.
Always obey the instructions that you find
on the packaging of the product.
14.7 Cleaning the drum
Regularly examine the drum to prevent rust
particles.
For a complete cleaning:
1. Clean the drum with special products for
stainless steel.
28 ENGLISH
To Next Page
Loading...
Need help?
General
