AEG MRC 4136 - Power Supply and Radio Tuning; Clock and Volume Settings; Switching the Device Off

English
44
WARNING:
Donotexposethebatteriestohightemperaturesordirectsunlight.Neverthrowbatter-
ies into the fire. There is a danger of explosion!
Power supply
• Insertthegridplugintoaproperlyinstalledthreeprongsocket.
• Makesurethegridvoltagecorrespondstotheguresontheratingplate.
• Ifyouhavenotinsertedabackupbattery,thestoredclocktimewillbelostassoonas
the power supply is interrupted.
Radio station tuning
1. Move the function switch (2) to the ON position.
2. Set the band selection switch (9) to FM or AM, depending on the frequency band you
want to listen to.
VHF = FM, Medium Wave = AM (Mono)
3. Turn the tuning control in order to tune in to a station.
4. If reception is too weak, change the position of the dipole antenna in order to improve
the reception.
5. An antenna is integrated in the device for the reception of the AM stations. The device
can be directed towards the transmitter by turning and changing its position. In this
frequency band, programs are only broadcast in mono.
Volume
The desired volume can be sent using the VOLUME regulator (15).
Setting of the Clock (24 h)
Hours: Simultaneously press the TIME button (8) and the HOUR button (3).
Minutes: Simultaneously press the TIME button (8) and the MIN button (4).
Switch-off
The device is switched off if the function switch (2) is in the “OFF” position.