AEG PROTECT 1 LCD - Page 20

UPS
UPS UPS
UPS model
modelmodel
model
1. Place the unit on a flat surface in its final location and install ‘Tower foot’ for
stability.
2. Install the unit to ground(optional): place 4pcs bolts (M8 is recommended)
to the final location previously, bolt’s position please refer to below, then fix
the unit to the bolts.
EBM model
EBM modelEBM model
EBM model
It is recommended to place EBM module(s) on the right side of the UPS.
1. Place the unit on a flat surface in its final location and install ‘Tower foot’ for
stability.
2. Install the unit to ground (optional): place 4pcs bolts (M8 is recommended)
to the final location previously, bolt’s position please refer to below, then fix
the unit to the bolts.