AEG Protect 2.33 2.0 - Alarms Level Screen (Menu 4.0)

56
Screen 3.6
Information about the set-point values:
IP.V and OP.V shows the desired values for the input voltage at the rectifier and the
output voltage.
In addition, you will see the maximum permissible voltage imbalance at the
rectifier and the bypass input, the current at the output and the battery charging
current. Furthermore, the current of the battery and the input will be displayed.
6.3.5. ‘‘ALARMS” LEVEL (SCREEN MENU 4.0)
When “Alarm” appears, in the main menu, you can only see one alarm, but you
can enter “Alarm” into the menu’ to check which alarms are in the current unit as
in the following:
Screen 4.0 “Alarms