35
i
Please shut down the entire system if you cannot
solve any problems which occur. Press the OFF
button for about 2 seconds. Disconnect the UPS
from the mains by pressing the mains input circui
breaker (Pos 3, page 26). Please contact ou
hotline (page 5).
8. When all displays are lit as described, switch on
your loads one after the other. Note the maximum
permitted UPS load when doing this.
i
Behaviour when switching off:
The behaviour after switching off the UPS with the
mains switch (OFF) can be defined with the
Software CompuWatch. The UPS can switch to
bypass mode or can be switched of right away.
To Next Page
Loading...
