BN 09 2671/01/01 - 30 / 50 -
6.7.3 Setup
The setup menu is accessible with a “user” or “supervisor” password and it allows
the modification of your system configuration. The default “user” password is
1111. For supervisor access password please contact factory. Any modification of
your system configuration is your responsibility. You risk damages on your battery
or equipment if the modification is done by a non specialized staff.
According to the factory setting configuration, the access to the "alarms" and "system" setup menus can differ. The
following paragraphs describe the menus access usual setup for a standard equipment. When a menu is not
accessible to the user, it is not displayed. When there is no menu accessible to the user, the message "SET NOT
ALLOWED" is displayed.
6.7.3.1 How to change “user” and “supervisor” password
Enter the Password setting as follows:
The first menu is to change the “supervisor” password.
PASSWORD SETTING
Next Change Exit
SUPERVISOR LEVEL
Next Change Exit
NEW PASSW: 1111
nter
FLOATING CHARGE
Monit Confg Cmnd
SETUP
Next Enter Exit
Password: 1111
nter
SYSTEM SETUP
Next Enter Exit
BATT.SELECTION
Next Enter Exit
ERIFY NEW: 0000
nter
Starting from the main menu select ‘Confg’.
Select ‘Next’ until the following menu is displayed.
Press ‘Ente
’.
With arrow keys, select the “supervisor” password and hit
‘Enter’
ke
.
Enter the system setup by hitting ‘Enter’ key.
Select ‘Next’ until the above menu is displayed.
Select ‘Change’ to enter the password setting menu.
Select ‘Change’.
With arrow keys, enter the new “supervisor” password
and hit ‘Enter’
ke
.
With arrow keys, confirm the new password and hit
‘Enter’
ke
.
To Next Page
Loading...
