AEG RCB76211TX - Page 24

EN -23-
If your fridge is not operating;
• Is there a power failure?
• Is the plug connected to the socket correctly?
• Is the fuse of the socket to which the plug is connected or the main fuse blown?
• Is there any failure at the socket? To check this, plug your refrigerator to a socket this
is surely operating.
If your fridge is not cooling enough;
• Is the temperature adju󰀬ment right?
• Is the door of your fridge opened frequently and left open for a long while?
• Is the door of fridge closed properly?
• Did you put a dish or food on your fridge so that it contacts the rear wall of your fridge
so as to prevent the air circulation?
• Is your fridge lled excessively?
• Is there adequate di󰀬ance between your fridge and the rear and side walls?
• Is the ambient temperature within the range of values specied in the operating manual?
ERROR TYPE MEANING WHY WHAT TO DO
SR – Set value
Blink on cooler
set value
screen
"Refrigerator
comp.
Not Cold enough"
Ideal temperature for
Ref. Compartment is
+4
o
C. If you see this
warning your foods
have risk of spoiling.
1. Set the refrigerator
temperature to colder
values or set the super
cooling mode until the
compartment gets to
normal temperature.
2. Do not open the door
much until this failure is
o󰀨.
SR – Set value
blink on freezer
and cooler set
value screen
"not cold enough
Warning"
It is combination of
"not cool enough"
error for both of the
compartments.
You will see this failure
when r󰀬 󰀬arting the
appliance. It will be o󰀨
after the compartments
gets normal temperature
SR – Set value
blink on cooler
set value
screen
Refrigerator
comp. too Cold
The foods 󰀬arts to
freeze because of
the too much cold
temperature
1. Check if the “Super
cooling mode” is on
2. Decrease the
refrigerator temperature
values
“--”
"Low voltage
Warning"
When the power
supply gets lower
than 170 V the
appliance gets to
󰀬eady position.
This is not a failure. This
prevents any damages
on the compressor. This
warning will o󰀨 after the
voltage gets required level