AEG RMB954E9VX - Page 15

15ENGLISH
7. USING THE DISPENSER
7.1 Using the ice maker after
installation
Before making ice for the 󰘰rst time, be
sure to prime the water supply system.
Air in new plumbing lines can result in
two or three empty ice maker cycles.
Furthermore, if the system is not 󰘱ushed,
the 󰘰rst ice cubes may be discolored or
have an odd 󰘱avor.
7.2 Priming the water supply
system
1. Begin 󰘰lling the system by pressing
and holding a drinking glass against
the dispenser.
2. Keep the glass in this position until
water comes out of the dispenser.
It may take about 1½ minutes.
3. Continue dispensing water for about
four minutes to 󰘱ush the system
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).
Dispenser
NOTE
The water dispenser has a
built-in device that shuts o󰀨 the
water ow after three minutes
of continuous use� To reset this
shuto󰀨 device, simply release
the dispenser paddle�
NOTE
After the initial 750 ml, water will
remain room temperature until
the tank has relled and been
given enough time to chill the
next 750 ml of water� May take
up to 8 hours to chill�
7.3 Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will 󰘰ll the ice bin from the
rear. Dispense some ice to force the ice
forward in the bin. This will allow the bin
to 󰘰ll completely.
7.4 Ice Maker and Storage Bin
Capacity
This ice maker should produce 1 Kilogram
of ice per 24 hours. The ice bin will hold
about 1,6 Kilogram of ice.
7.5 Turning the fresh food
ice maker on and o󰀨
IMPORTANT
The ice maker is turned on at the
factory so it can work as soon as
the refrigerator is installed� If it is
not possible to connect a water
supply, set the ice maker’s On/
O󰀨 feature to O󰀨; otherwise, the
ice maker’s ll valve may make
a loud chattering noise when it
attempts to operate without water�
Ice production is controlled by the ice
maker’s On/O󰘯 feature on the control
panel. Pressing the On/O󰘯 feature turns
the ice maker on & o󰘯.
NOTE
The ice maker also has a
built-in plastic signal arm that
automatically stops ice production
when the ice bin is full� This
signal arm should not be used
to manually stop the ice maker�
IMPORTANT
Turning o󰀨 the ice maker simply
disables ice making� Existing ice
can still be dispensed, and water
can be dispensed�