Something not Working
818 36 23-02/7 39
If after the above checks there is still a fault, call your local AEG Service
Force Centre.
In-guarantee customers should ensure that the above checks have been
made as the engineer will make a charge if the fault is not a
mechanical or electrical breakdown.
Please note that proof of purchase is required for in-guarantee service
calls.
Temperature display shows
a square or a letter.
There is a function fault.
Please inform customer
service. Do not open the
doors of the appliance
again.
Warning tone sounds, red
warning indicator light and
temperature display are
flashing.
Temperature warning.
Please check in "Control
and Information System"
section.
Interior illumination does
not function.
Light bulb is defective.
Important: The interior
lighting switches off auto-
matically after 7 minutes.
Please refer to "Replacing
the Light Bulb" section.
Water on the floor or on
storage shelves.
Water drain hole is
blocked.
See the "Maintenance and
Cleaning" section.
Heavy build up of frost,
possibly also on the door
seal.
Door seal is not air tight
(possibly after changing
over the hinges).
Carefully warm the leak-
ing sections of the door
seal with a hair dryer (not
hotter than approx. 50 °C).
At the same time shape the
warmed door seal by hand
such that it sits correctly.
The compressor does not
start immediately after
changing the temperature
setting.
This is normal, no error has
occurred.
The compressor starts after
a period of time.
Noise Appliance is not level.
Readjust the front levelling
feet.
Refer to Normal Operating
Sounds
Symptom Possible Cause Solution
To Next Page
Loading...
