1
2
G
RI
ZU
A
F
U
Lock button for switch locking
Modifications: Text, diagrams and data are correct at the time of printing. In the interest of continuous
improvement of our products, technical specifications are subject to alteration without prior notice.
Ergonomically designed
housing with soft grip.
Switch trigger for
switching the machine on
and off, and for smooth
starting and varying
speed.
Auxiliary handle, has an integral depth
gauge and can be rotated in various
positions.
(according to standard equipment)
Reversing lever for changing from forward to
reverse rotation – due to a lockout mechanism,
switching the lever is only possible if the On-/Off
switch is not depressed.
Fully insulated metal gear box for long durability and
protection from electric shock.
Selector lever for switching between drilling and
percussion drilling.
Gear lever for switching between 1st and
2nd gear.
Keyless chuck for tightening
without a key.
(according to standard equipment)
Three jaw chuck
(according to standard
equipment)
Built-in safety clutch helps prevent the
machine from rotating if the drill bit jams.
Bit reception – it is possible to fit drill bits directly
into the working spindle.
Torque adjustment knob
(cut-out)
(only applicable for
SB2E 1200 RST)
Anti–Vibration–System AVS. The drive
motor is suspended independently of the
switch handle, insulating elements absorb
up to 50 % of the vibration when hammer
drilling.
The electronic gentle start-up raises the
r.p.m. continuously up to the maximum set
so that you can drill with pin-point
accuracy.
(only applicable for SB2E 1200 RST)
Adjuster wheel for speed presetting
To Next Page
Loading...
Need help?
General
