Problem Possible cause Solution
There is no cold air circula‐
tion in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
Use LED bulbs (E14 base)
only. The maximum power is
shown on the lamp unit.
CAUTION!
Disconnect the plug from the
mains socket.
1. Pull the left side of the lamp cover
with your fingers to unlock it. Remove
the cover by pulling it towards
yourself.
2. Replace the bulb with one of the
same power and shape, specifically
designed for household appliances.
3. Install the lamp cover.
4. Connect the plug to the mains
socket.
5. Open the door.
Make sure that the light switches on.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
www.aeg.com14
To Next Page
Loading...
Need help?
General
