Problem
1)
Possible cause Remedy
It is not possible
to select an op-
tion. An acoustic
signal is emit-
ted.
The option you tried to select is
not available for the selected pro-
gramme.
Turn the tumble dryer off and on.
Change the programme or option
as required.
There is no
drum light
Defective drum lamp. Contact the service centre to re-
place the drum lamp.
Unexpected du-
ration time ap-
pears on the dis-
play.
The drying duration is calculated
according to load size and damp-
ness.
This is automated - the appliance
is working correctly.
A programme is
inactive.
The water container is full. Drain the water container, push
the Start/Pause button.
3)
The drying cycle
is too short.
The load size is small. Select a time programme. The
time value must be related to the
load. To dry one item or a small
amount of laundry we recommend
short drying times.
The laundry is too dry. Select an appropriate time pro-
gramme or a higher dryness level
(e.g.
extra dry
)
Drying cycle too
long
6)
The filter is clogged. Clean the filter.
The load is too large. Do not exceed the maximum load
size.
The laundry was not spun suffi-
ciently.
Spin the laundry well in the wash-
ing machine.
Too low or too high room temper-
ature - this is not the appliance
malfunction.
Ensure a room temperature higher
than +5°C and lower than +35°C.
Optimal room temperature to ach-
ieve best drying results is between
19°-24°C.
1)
If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Select a new
programme. Touch the Start/Pause button. If the appliance does not operate contact the service centre
and provide the error code.
2)
Follow the programme description — see the PROGRAMMES chapter .
3)
See the
CARE AND CLEANING
chapter.
4)
Only dryers with the Dryness option.
5)
See the HINTS AND TIPS chapter .
6)
Note: After a maximum of 5 hours the drying cycle ends automatically.
www.aeg.com22
To Next Page
Loading...
