AEG T8DEE48S - Page 22

Problem
1)
Possible cause Remedy
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
The option you tried to select is not
available for the selected pro‐
gramme.
Turn the tumble dryer off and on.
Change the programme or option
as required.
There is no
drum light
Defective drum lamp. Contact the service centre to re‐
place the drum lamp.
Unexpected du‐
ration time ap‐
pears on the
display.
The drying duration is calculated
according to load size and damp‐
ness.
This is automated - the appliance
is working correctly.
A programme is
inactive.
The water container is full. Drain the water container, push the
Start/Pause button.
3)
The drying cycle
is too short.
The load size is small. Select a time programme. The
time value must be related to the
load. To dry one item or a small
amount of laundry we recommend
short drying times.
The laundry is too dry. Select an appropriate time pro‐
gramme or a higher dryness level
(e.g. extra dry )
Drying cycle too
long
6)
The filter is clogged. Clean the filter.
The load is too large. Do not exceed the maximum load
size.
The laundry was not spun suffi‐
ciently.
Spin the laundry well in the wash‐
ing machine.
Too low or too high room tempera‐
ture - this is not the appliance mal‐
function.
Ensure a room temperature higher
than +5°C and lower than +35°C.
Optimal room temperature to ach‐
ieve best drying results is between
18°-25°C.
1)
If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on. Select a new
programme. Touch the Start/Pause button. If the appliance does not operate contact the service centre
and provide the error code.
2)
Follow the programme description — see the PROGRAMMES chapter .
3)
See the
CARE AND CLEANING chapter.
4)
Only dryers with the Dryness option.
5)
See the HINTS AND TIPS chapter .
6)
Note: After a maximum of 5 hours the drying cycle ends automatically.
www.aeg.com22