AEG WS 11-125 - Symbols and Maintenance

17
17
Never lead the workpiece to the grinding disk with your hand.
Under extreme conditions (e.g. smooth-grinding metals with the arbour
and vulcanized  bre grinding wheel), signi cant contamination can build
up on the inside of the angle grinder. For safety reasons, in such conditions
the inside should be cleaned thoroughly of metal deposits and a residual
current device (FI, RCD, PRCD) must be connected in series. If the residual
current device responds, the machine must be sent for repair.
For accessories intended to be  tted with threaded hole wheel,
ensure that the thread in the wheel is long enough to accept the
spindle length.
When cutting-o material, use the closed safety guard from the
accessories range.
SPECIFIED CONDITIONS OF USE
The angle grinder may be used for cutting, grinding, sanding and
wire brushing a wide range of materials, such as metal or stone. If
you have any doubts, please refer to the instructions supplied by the
accessory manufacturer.
Do not use this product in any other way as stated for normal use.
MAINS CONNECTION
Connect only to single-phase AC current and only to the system
voltage indicated on the rating plate. It is also possible to connect
to sockets without an earthing contact as the design conforms to
safety class II.
ECDECLARATION OF CONFORMITY
The built-in electronic will k
eep a constant speed even under
increased load.
Should the machine be overloaded
, the rotational speed is being
reduced to standstill.
SYMBOLS
Please read the instructions carefully before
starting the machine.
CAUTION! WARNING! DANGER!
Always wear goggles when using the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation
in accordance with national law, electric tools that
have reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
SYMBOLS
Please read the instructions carefully before
starting the machine.
CAUTION! WARNING! DANGER!
Always wear goggles when using the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation
in accordance with national law, electric tools that
have reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
MAINTENANCE
SPECIFIED CONDITIONS OF USE
The angle grinder may be used for cutting (WS 11-125 only), grinding,
sanding and wire brushing a wide range of materials, such as metal or
stone. If you have any doubts, please refer to the instructions supplied
by the accessory manufacturer.
Do not use this product in any other way as stated for normal use.
Use only AEG accessories and spare parts. Should components need
to be replaced which have not been described, please contact one of
our AEG service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the machine type printed as well as the six-digit No. on the label and
order the drawing at your local service agents or directly at:
Techtronic Industries (Australia) Pty. Ltd.
Level 1, 660 Doncaster Road,
Doncaster, VIC 3108,
Australia
Techtronic Industries N.Z. Limited
18-26 Amelia Earhart Avenue,
Mangere, Auckland 2022,
New Zealand