1 2
How to use emergency key
How to install the batteries
How to open the safe
We don’t install batteries at the factory to avoid corrosion. You will need to
open the door with the emergency key in order to install the batteries.
Please read this instruction carefully and following instructions before
operating the safe.
These keys allow you to open the safe at all time, even when the batteries are
run out or when you have forgotten the codes. Please keep the emergency
key in a safe place but not inside the safe.
1、Take off the lock cover carefully, it is located in the middle of the
electronic lock panel.
2、Insert the emergency key into the keyhole and turn counterclockwise.
3、Turn the knob clockwise to open the door.
For the first time, you should use the emergency key to open the safe.
Then remove the batteries housing cover and place the batteries(4*1.5V,
type AA) into battery box correctly.
For the first time, you should use the emergency key to open the safe, and
install the batteries.
After batteries installed, you could enter the factory password 1-5-9, and press
the green ✔to confirm, there will be 2 bees with a flashing green light, then turn
the knob clockwise to open the door.
How to lock the safe
Close the door and turn the knob counter-clockwise.
1、Basic feature
(1) Each time you press the number button, the green light flashes and
the buzzer sounds 1 time;
(2) Yellow light is undervoltage indicator. If press any one button when
the voltage is equal to or less than 4.5V (+ / - 0.2V), the yellow light
flashes twice, and the buzzer sounds twice, that’s indicating low
voltage . Working voltage Range: 4.0v-6.8v.
(3) Red light is error light.
2、Opening steps
Enter the password,each time you press the number, the green light flashes
and the buzzer sounds one time. Then press the green to confirm, there will
be 2 bees and the green light will flash twice if your code has been entered
successfully.
To Next Page
Loading...