EasyManuals Logo

Aeon Z-Stick User Manual

Aeon Z-Stick
4 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
SerialAPI-Mode : Allowing a Host Processor To Take Control of the Z-Stick and Take Part in
the Z-Wave Network
1. To initiate SerialAPI-Mode, plug the Z-Stick into the USB connector of the host.
Note: While in SerialAPI-mode, the Z-Stick is always listening (it is awake and always in
RX receive mode) for instructions and acts as a Z-Wave adapter and responds to
commands sent through USB by the host processor software.
Note: Pressing the Z-Stick button will not have any effect while in SerialAPI-Mode.
Other Functions:
Factory reset on the Z-Stick: This must be done through the host software which takes
control of the Z-Stick USB adapter while the Z-Stick is in SerialAPI-Mode. Please consult
the instruction manual of the host software to perform a network reset (i.e. factory
reset on the Z-Stick). This function can only be preformed via the host software.
Add the Z-Stick to a pre-existing Z-Wave network: This must be done through the host
software which takes control of the Z-Stick USB adapter while the Z-Stick is in SerialAPI-
Mode. Please consult the instruction manual of the host software to add the Z-Stick to a
pre-existing Z-Wave network (i.e. “Learn”, “Sync”, “Add as Secondary Controller”, etc.).
This function can only be preformed via the host software.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Aeon Z-Stick and is the answer not in the manual?

Aeon Z-Stick Specifications

General IconGeneral
BrandAeon
ModelZ-Stick
CategoryModem
LanguageEnglish