Need help?Do you have a question about the AERMEC FCZ 300 and is the answer not in the manual?
Emphasizes reading all instructions carefully, especially those with 'DANGER' or 'ATTENTION' signals.
Explanation of danger symbols related to power supply and electrical hazards.
Explanation of danger symbols related to moving parts and mechanical hazards.
Emphasizes following instructions, using qualified personnel, and adhering to standards.
Specifies that installation works must be performed by experienced and qualified staff.
Explains how to use the control panel for fan speed selection and power on/off.
Warns about electrical and water circuits, requiring skilled personnel for safety.
Specifies that the fancoil must be powered only with single-phase 230 V.
Stresses the importance of frequent filter cleaning for efficient operation.
Reiterates the need to disconnect power supply before performing operations on the unit.
Emphasizes that installation must be performed by technicians with necessary expertise.
Lists key steps like removing filters, housing, securing to wall, and making connections.
Refers to wiring diagrams for making electrical connections correctly.
Warning to ensure power supply is disconnected before electrical operations.
Electrical connections must be done by technicians with expertise in plants.
Specifies maximum and recommended water inlet temperatures and operating pressure.
Defines allowable room temperature and relative humidity limits for operation.
States the required electrical power supply for the unit.
Details minimum and maximum water flow rates for different FCZ models.
Explains how minimum water temperature prevents condensation in cooling mode.
Details acceptable limits for various water parameters like hardness, chlorides, and pH.
Warns against installing in areas with flammable gases or acidic/alkaline substances.
Diagram showing the electrical wiring connections for the unit.
Lists required spaces around the unit for installation, operation, and maintenance.
Provides detailed measurements and dimensions for various FCZ models.
Illustrates the location and orientation of water connections on the unit.
Specifies the thread sizes for hydraulic connections for different coils and models.
Details the electrical schematic showing connections between components.
To Next Page
General