AeroComm AC5124 - Page 6

11/24/03 6
FCC INFORMATION
FCC INFORMATIONFCC INFORMATION
FCC INFORMATION
Labeling Requirements
Labeling RequirementsLabeling Requirements
Labeling Requirements
RF Exposure AC5124-10
RF Exposure AC5124-10RF Exposure AC5124-10
RF Exposure AC5124-10
RF Exposure AC5124-200
RF Exposure AC5124-200RF Exposure AC5124-200
RF Exposure AC5124-200
WARNING:
WARNING: WARNING:
WARNING: The Original Equipment Manufacturer (OEM) must ensure that FCC labeling
requirements are met. This includes a clearly visible label on the outside of the
OEM enclosure specifying the appropriate AeroComm FCC identifier for this
product as well as the FCC Notice above. The FCC identifiers are listed above
in the Agency Identifier Numbers section.
WARNING:
WARNING: WARNING:
WARNING: This equipment has been approved for portable applications where the
equipment can be used in direct contact with the human body. Excessive RF
exposure should be avoided.
The preceding statement must be included as a CAUTION statement in
manuals for products operating with Antennas 3, 4, 5, 6, 7, 14 and 15 in the
previous table to alert users on FCC RF Exposure compliance.
WARNING:
WARNING: WARNING:
WARNING: To satisfy FCC RF exposure requirements for mobile and base station
transmitting devices, a separation distance of 20cm or more should be
maintained between the antenna of this device and persons during operation.
To ensure compliance, operations at closer than this distance is not
recommended.
The preceding statement must be included as a CAUTION statement in
manuals for OEM products to alert users on FCC RF Exposure compliance.