front leading edge tube, allowing the sprog end to come outside the sail at the access zipper
(fig. 2 and fig. 3).
Figure 1 Figure 2
Figure 3 Figure 4
Figure 5
3.3. Tighten the sail along the leading edge by
putting the sail mount webbing into the slot in
the end cap of the outer leading edge tube.
Secure the sail mount webbing to the outer
leading edge with the sail mount webbing
Velcro (fig. 4 and fig. 5).
NOTE:
The sail is attached to the leading edge tube
using an inner strap, the outer strap is
auxiliary and serves only as a tensioning
handle.
To Next Page