6
• The gap between the mattress and the sides of the cot may not exceed 3 cm in length and width. Mattress size is mentioned at the
inside of the mattress cover.
• Do not use the mattress if any part is broken, torn or missing and use only spare parts approved by the manufacturer.
• Be aware of the risk of open re and other sources of strong heat, such as electric bar res, etc. in the near vicinity of the cot.
• For the mattress protector, shrinkage up to 3% after domestic washing is normal.
• For safety reasons: only combine this mattress pack with an ‘AeroSleep SafeSleep Bed Bumper’.
• Remove the paperclip after use, keep out of reach of babies and children younger than 3 years.
• The mattress will quickly take on its original shape if you
unroll it as soon as you receive it. Remove the cover and let
the foam rest for up to 72 hours without placing any weight
on it.
• Use the zipper clip from this manual to zip open the
mattress cover.
• Attach the paperclip to the zipper to open the mattress cover.
• Use the mattress protector with the honeycomb structure
facing the baby.
• Make sure the mattress protector covers the complete surface
of the mattress.
• Only the combination of the perforated AeroSleep
®
tted
sheet and the AeroSleep
®
mattress protector provides the
optimal ‘safe sleep’ experience.
• Extra tip for a safe night’s sleep: use a sleeping bag instead of
a blanket.
Instructions for use
Warnings
More info: www.aerosleep.com
Designed and manufactured by QLEVR - Waterkeringstraat 21 - ZUID IV, 9320 Erembodegem, BELGIUM
Meets the requirements of EN 16 890
To Next Page
Loading...