ENGLISH
16
Replacing the blade set
The blade set is subject to wear. Even if you look after the
appliance properly, the cutting performance will deteri-
orate. Replace the blade set when it is worn. The blade
set can be ordered separately as a spare part from
Aesculap Customer Service (see addresses at the end of
these instructions).
WARNING
Damage to casing when screwing on
clipper head!
¾ Do not over tighten the screw.
¾ Make sure the On/Off switch 4
is in the 0 position.
¾ Remove the Allen key 13 from
the base of the charging unit
and use it to loosen the blade
set screw 6.
¾ Loosen the screw fully and re-
move it.
¾ Push the blade set upwards with
your thumb.
¾ Push the new blade set on until
it snaps into place and secure it
using the screw.
To Next Page
Loading...
