17
4
4
Use a drill or screwdriver to install the included
mounting screws at the eyelet marks. Hang the
bracket from the mounting screws.
Reattach the lter cartridges to the bracket by
hand-twisting them in sequential order, with
cartridge 3 sitting directly below the word “ow”
on the bracket. Refer to the numbers on each
cartridge and the diagram on the front of the
bracket to guide you.
Run cold water for 5 minutes or until the water
runs clear with few, if any, bubbles.
Drink up and enjoy the convenience of clean water
on demand.
To ensure your system works eciently and eectively,
you must prime it prior to rst use.
18
To Next Page
Loading...