Wireless
Headphones
User's Manual
取扱説明書
使用说明书
Product : Bluetooth Headphone
Model number : AG-WHP01K
FCC ID : 2AX2R-FI-UX3DPL
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Product Certification Information
/
製品認証情報/产品认证资讯
Complies with
IMDA Standards
DA108470
210 -236498
CMIIT ID : 2021DJ11765
WHP 01K
2M K
The power delivered by the charger must be
between min 2.3 Watts required by the radio
equipment, and max 5.0 Watts in order to
achieve the maximum charging speed.
2.3
-
5.0
W
To Next Page
Need help?
General
