- 3 -
Description
The MR360R is a laser cell of reception
especially conceived for all your machine
control applications. Accurate, reliable, robust
and waterproof, it will be bear at the difficult
conditions of the building sites.
It detects the beam from visible or infrared
laser. Four large detection windows pick up the
beam on 360 degrees with a range of 25 cm.
Using the MR360R
Press the red ‘On/Off’ button on the bottom of
the receiver.
Each led will blinks in sequence as a self test.
The receiver will be in coarse mode.
To change the accuracy to fine mode, press
again the red ‘On/Off’ button. The two leds
located each side of the center led will blink 3
times simultaneously.
To turn off the receiver, keep the red ‘On/Off’
button pressed during 3 seconds. Leds will blink
from the center to the two extremities.
Attachment
For quick setup from the machine, the receiver
can be ordered with two adjustable clamps or
with magnets.
The clamps on the MR360R can be attached to
a round pipe with a minimum diameter of 40
mm.
Power
The MR360R receiver is equipped with
rechargeable battery (NiCd type). A 110V/240V
charger is included. Charging time is 16 hours.
To Next Page
Loading...
