To Next Page

To Previous Page

1.2.2 Safe Driving

Read and understand the general safety instructions. Make sure that:

• You always obey your local road trac regulations and the speed limits

• The drawbar and the parking jack are in the drive position

• The machine is in the transport position

• The tailgate is not open and locked

• The trailed steering axle (if present) is locked

• All parts that move (for example the folding components and covers) are locked

• The wrapping ring and wrapping table are in the transport position

• The control panel and the hydraulic system of the tractor are o

• All the lamps on the machine operate correctly and are clean from dirt

• Set the work lamps to "OFF"

• Examine the operation of the brakes before you start to drive. Do not drive with the machine if there is a

problem with the brakes

• Do not make sudden turns when on a slope

• Drive slower when on a down slope

• Do not disengage the clutch of the tractor or change gears on a slope

• Do not transport one more person, unless there is a second seat in the tractor.

1.2.3 Safe Driving on Hillsides

Add to the general safety instructions and the other instructions for safe driving:

• Only persons with approval can operate the machine on slopes

• Do not open the tailgate in very bad locations for example on a slope and think how the change in the

point of gravity of the machine, because of the open tailgate will have an eect

• Do not put the machine in dangerous locations on a slope, know the centre of gravity of the machine

when the tailgate is open, or the wrapping ring lifted

• Always use an applicable tractor for slopes.

AGCO LELY RPC 130 F User Manual

Questions and Answers: