8. Make sure that the film roll is tight between
the top and lower roll holder. Wind o and
put the film through the stretch rollers, refer
to the scheme on the decal.
9. Carefully move the stretch rolls against the
film roll with the handle (1).
10. Make a knot and position the knot behind the
notch (6).
GUID-9080EE90-60E3-45E0-A74F-C5D0E4EB1D92-high.jpg [High]
Fig. 39
11. Pull the safeguard (5) up.
In the condition of films with glue: the glued side must be on the bale.
3.4.10 Operating Position of the Bale Mat (optional)
GUID-4DE2CFC5-C915-4D9B-BEF7-5D6C61D53ED9-high.jpg [High]
Fig. 40
Procedure
1. Make sure that the tractor engine is "OFF" and the key removed.
2. Release the wrapping ring safeguard 1 and the wrapping ring safeguard 2.
3. Start the tractor engine, on the E-Link Pro go to the page “Adv. Menu > Manual Control”.
a) Make sure that the wrapping table is in the work position (down), use the line “Table tilt”.
4. Stop the tractor engine and remove the key.
5. Remove the pins that attach the bale mat.
GUID-D29F0137-C50B-49EB-817D-2392C70EF661 [V1]
3. Operation
94 Baler Wrapper Combination
4900.LE.EN01
To Next Page
Loading...
Need help?
General
