Agile Helicopter is a Trademark of Flight Research Rc Europe , Proudly made by KDS Model Shenzhen
Page 18
轴承
Bearing
φ 5Xφ 10X4
尾中联
Tail rotor hub
尾桨夹
Tail blade grip
防松螺 母 M3
Locknut
垫片
Washer
7X9.8X0.5
球头 C
Bails
垫片
Washer
3X8X1.0
止推轴 承
Thrust bearing
尾推滑块 铜套
Tail picth slider copper bush
法兰轴 承
Flange Bearing
φ 7Xφ 11X3
尾推轴承 座
Tail picth slide bearing mount
尾推滑块U型 臂
Tail picth slider U arm
E形扣
E ring
铝套
Aluminum sleeve
球头扣
Ball lingk
销子
Pin
止推轴承滚珠 涂润滑油
Thrust bearings need lubricating oil
尾桨夹组装完成后向外拉紧,此处有约0. 5mm间隙属正常现象
After the Tail blade grip is assembled, pull tight on both sides .
The clearance of about 0.5mm in this position is normal.
尾此步骤出 厂己打螺丝 胶
Screw glue has been
applied at the factory
外径大
Larger ID
外径小
Smaller ID
To Next Page
Loading...