Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide 29
Installation and Start Up 2
Installing Your Computer
Installing Your Computer
Detailed instructions for installing your computer are specific to the type
and configuration of the computer and are provided with it. This section
gives a checklist of the main installation procedures; refer to the
documentation that was delivered with your computer for detailed
information.
Setting up the computer
✔ If you have any additional accessories, install them before you set up
your computer:
• Additional memory, refer to your computer documentation.
• Additional mass storage devices (hard disk drive, tape drive, DVD),
refer to your computer documentation.
• Accessory boards excluding USB to GPIB interface, refer to your
computer documentation.
• USB to GPIB interface, see “Installing an GPIB Interface” on page 81.
✔ Connect the keyboard and mouse to the sockets at the back of the
computer.
✔ Connect the display unit to the video socket at the back of the
computer.
✔ Connect the printer cable to the socket on the printer and to the
correct printer interface socket on the back of the computer.
✔ Connect the GPIB connector of the USB to GPIB interface to the
spectrophotometer’s GPIB connector and the USB connector to the
computer or connect your LAN cable from the spectrophotometer to the
LAN connector on the computer.
If you have more GPIB instruments connected to your computer, see
Chapter 6, “Installing an GPIB Interface” for correct GPIB cabling,
because you must observe some basic rules. For correct setup, see
Chapter 7, “LAN Communication, Installation, Connection and
Configuration”.
To Next Page
Loading...
