Page 7 of 8 E5061B-05
Step-7: Connect the cable E5061-61631(which is re-used item from the original instrument) and make a shape
correctly as the picture.
Step-8: Connect the cable to J18 port on the CPU board, then paste a cable clamp on the sidewall of the PSU as the
picture.
Then, clamp the cable properly and run through under the bar properly then tie the cable with other cables
together with a cable tie 1400-0249.
Step-9: Put the front assembly module in front of the chassis as the picture, then connect another USB connector of
the cable to the front assembly module as the picture.
Step-10: Clamp the cable as the picture.
To Next Page
Loading...
