Agilent Technologies n5181a - Page 211

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 195
SCPI Compatibility
E4428C/38C Compatible Commands
:OUTPut[:STATe] ON|OFF|1|0
:OUTPut[:STATe]?
✓
Route Subsystem
:ROUTe:HARDware:DGENerator:... – This subsystem is not supported.
Status Subsystem
:STATus:OPERation:BASeband:CONDition? –
:STATus:OPERation:BASeband:ENABle <value>
:STATus:OPERation:BASeband:ENABle?
–
:STATus:OPERation:BASeband:NTRansition <value>
:STATus:OPERation:BASeband:NTRansition?
–
:STATus:OPERation:BASeband:PTRansition <value>
:STATus:OPERation:BASeband:PTRansition?
–
:STATus:OPERation:BASeband[:EVENt]? –
:STATus:OPERation:CONDition? ✓
:STATus:OPERation:ENABle <value>
:STATus:OPERation:ENABle?
✓
:STATus:OPERation:NTRansition <value>
:STATus:OPERation:NTRansition?
✓
:STATus:OPERation:PTRansition <value>
:STATus:OPERation:PTRansition?
✓
:STATus:OPERation[:EVENt]? ✓
:STATus:PRESet:STATus:QUEStionable:CALibration
:ENABle <value>
:STATus:QUEStionable:CALibration:ENABle?
✓
:STATus:QUEStionable:BERT:CONDition?
:STATus:QUEStionable:BERT:ENABle <value>
:STATus:QUEStionable:BERT:ENABle?
–
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks