Agilent Technologies n5181a - Page 223

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 207
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:LIST:TRIGger:SOURce
BUS|IMMediate|EXTernal|KEY
[:SOURce]:LIST:TRIGger:SOURce?
✓
[:SOURce]:LIST:TYPE LIST|STEP
[:SOURce]:LIST:TYPE?
✓
[:SOURce]:LIST:TYPE:LIST:INITialize:FSTep ✓
[:SOURce]:LIST:TYPE:LIST:INITialize:PRESet ✓
[:SOURce]:SWEep:CONTrol:STATe ON|OFF|1|0
[:SOURce]:SWEep:CONTrol:STATe?
–
[:SOURce]:SWEep:CONTrol:TYPE MASTer|SLAVe
[:SOURce]:SWEep:CONTrol:TYPE?
–
[:SOURce]:SWEep:DWELl <value>
[:SOURce]:SWEep:DWELl?
✓
[:SOURce]:SWEep:GENeration ANALog|STEPped
[:SOURce]:SWEep:GENeration?
✓ Command accepted without error but does
nothing.
[:SOURce]:SWEep:MODE AUTO|MANual
[:SOURce]:SWEep:MODE?
✓
[:SOURce]:SWEep:POINts <value>
[:SOURce]:SWEep:POINts?
✓
[:SOURce]:SWEep:TIME 10mS - 99S
[:SOURce]:SWEep:TIME?
✓
[:SOURce]:SWEep:TIME:AUTO ON|OFF|0|1
[:SOURce]:SWEep:TIME:AUTO?
✓
Low Frequency Output Subsystem
[:SOURce]:LFOutput:... – This subsystem is not supported.
Phase Modulation Subsystem
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks