Agilent Technologies n5181a - Page 225

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 209
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:PM[1]|2:INTernal[1]|2:FREQuency
<value><unit>
[:SOURce]:PM[1]|2:INTernal[1]|2:FREQuency?
✓
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:RATE
<value><unit>
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:RATE?
–
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME
<value><unit>
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TIME?
–
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TRIGger
IMMediate|KEY|EXTernal|BUS
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TRIGger?
–
[:SOURce]:PM[1]|2[:DEViation]:TRACk ON|OFF|1|0
[:SOURce]:PM[1]|2[:DEViation]:TRACk?
–
[:SOURce]:PM[1]|2:SOURce
INT[1]|INT2|EXT[1]|EXT2
[:SOURce]:PM[1]|2:SOURce?
✓ The Agilent MXG accepts the EXT2 parameter
but only has a single external output and
selects EXT on the signal generator if EXT2 is
used.
[:SOURce]:PM[1]|2:STATe ON|OFF|1|0
[:SOURce]:PM[1]|2:STATe?
✓
[:SOURce]:PM[1]|2[:DEViation] <value><unit>
[:SOURce]:PM[1]|2[:DEViation]?
✓
[:SOURce]:PM[:DEViation]:STEP[:INCRement]
<value><unit>
[:SOURce]:PM[:DEViation]:STEP[:INCRement]?
✓
Power Subsystem
[:SOURce]:POWer:ALC:BANDwidth|BWIDth
<num>[freq suffix]
[:SOURce]:POWer:ALC:BANDwidth|BWIDth?
✓
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks