Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 215
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:BURSt:STATe ON|OFF|1|0
[:SOURce]:BURSt:STATe?
✓
[:SOURce]:BURSt:TYPE:EXT LOG|LIN
[:SOURce]:BURSt:TYPE:EXT?
–
[:SOURce]:BURSt:TYPE:INT LOG|LIN
[:SOURce]:BURSt:TYPE:INT?
–
[:SOURce]:BURSt:TYPE[:ALL] LOG|LIN –
[:SOURce]:DM:EXTernal:FILTer 40e6|THRough ✓ Commands are accepted without error by the
signal generator, but no action occurs. But
the following query is not supported:
[:SOURce]:DM:EXTernal:FILTer?
If the query is used, an
[:SOURce]:DM:EXTernal:FILTer:AUTO ON|OFF|1|0 ✓ Supported but the following query is not
supported:
[:SOURce]:DM:EXTernal:FILTer:AUTO?
[:SOURce]:DM:EXTernal:HCRest[:STATe]
ON|OFF|1|0
[:SOURce]:DM:EXTernal:HCRest[:STATe]?
✓
[:SOURce]:DM:EXTernal:POLarity
NORMal|INVert|INVerted
[:SOURce]:DM:EXTernal:POLarity?
✓
[:SOURce]:DM:EXTernal:SOURce
EXTernal|INTernal|BBG1|OFF|SUM
[:SOURce]:DM:EXTernal:SOURce?
✓ Supported but the following parameters are
not supported: |BBG2|BBG3|BBG4|EXT600|
[:SOURce]:DM:IQADjustment:BBG[1]|2:DELay
<value><unit>
[:SOURce]:DM:IQADjustment:BBG[1]|2:DELay?
✓
[:SOURce]:DM:IQADjustment:BBG[1]|2:DELay:EVENt
s ON|OFF|1|0
[:SOURce]:DM:IQADjustment:BBG[1]|2:DELay:EVENt
s?
✓
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks
To Next Page
Loading...
