Agilent Technologies n5181a - Page 233

Agilent N5181A/82A MXG Signal Generators SCPI Command Reference 217
SCPI Compatibility
E4428C/38C Compatible Commands
[:SOURce]:DM:IQADjustment:QOFFset
<value><unit>
[:SOURce]:DM:IQADjustment:QOFFset?
✓
[:SOURce]:DM:IQADjustment:QSKew <value><unit>
[:SOURce]:DM:IQADjustment:QSKew?
✓
[:SOURce]:DM:IQADjustment[:STATe] ON|OFF|1|0
[:SOURce]:DM:IQADjustment[:STATe]?
✓
[:SOURce]:DM:MODulation:ATTen <value><unit>
[:SOURce]:DM:MODulation:ATTen?
✓
[:SOURce]:DM:MODulation:ATTen:AUTO ON|OFF|1|0
[:SOURce]:DM:MODulation:ATTen:AUTO?
✓
[:SOURce]:DM:MODulation:ATTen:EXTernal
DEFault|MANual|MEASure
[:SOURce]:DM:MODulation:ATTen:EXTernal?
✓
[:SOURce]:DM:MODulation:ATTen:EXTernal:LEVel
<value> <volt_units>
[:SOURce]:DM:MODulation:ATTen:EXTernal:LEVel?
✓
[:SOURce]:DM:MODulation:ATTen:EXTernal:LEVel:M
EASurement
✓
[:SOURce]:DM:MODulation:ATTen:OPTimize:BANDwid
th <value> <bw_rate_units>
[:SOURce]:DM:MODulation:ATTen:OPTimize:BANDwid
th?
✓
[:SOURce]:DM:MODulation:FILTer THRough ✓ Supported but the following query generates
an error: –113, Undefined header:
[:SOURce]:DM:MODulation:FILTer?
[:SOURce]:DM:MODulation:FILTer:AUTO
ON|OFF|1|0|2.1e6|40e6|
[:SOURce]:DM:MODulation:FILTer:AUTO?
✓ Commands are accepted by the signal
generator, but no action is taken. (An error
–113, Undefined header will be displayed
on the signal generator.)
Table 6-2 E4428C/38C Program Codes and Equivalent SCPI Sequences
3 = Supported by Agilent MXG
– = Not supported by Agilent MXG
N51xxA
Remarks