Agilent Technologies n5181a - Page 266

250 Agilent N5181A/82A MXG Signal Generators SCPI Command Reference
Index
Phase Ref Set softkey, 39
polarity
markers
dual ARB subsystem, 151
Power On Last Preset softkey, 105
Power Search Manual Auto softkey, 50, 51, 52
power subsystem keys, 54
ALC Off On, 52
Ampl, 42, 54
Ampl Offset, 56
Ampl Ref Off On, 55
Ampl Ref Set, 55
Ampl Start, 42, 55
Ampl Stop, 42, 56
Amplitude, 54, 57
Atten Bypass Off On, 53
Atten Hold Off On, 53
Do Power Search, 50, 51, 52
Off, 42, 54
Power Search Manual Auto, 50, 51, 52
Set ALC Level, 50
Set Atten, 52
precise talking and forgiving listening, 7
Preset hardkey, 106
Preset List softkey, 21, 47, 48
presetting registers, 93
presetting, transition filters, 93
programming commands
8656b, 236
8657a, 236
8657b, 236
8657d, 236
8657j, 236
programming guide, xv
protection state, 54
pulse modulation subsystem, 131
pulse modulation subsystem keys, 134
Adjustable Doublet, 135
Delay Step, 131
Ext Pulse, 135
Free- Run, 135
Gated, 135
Pulse Delay, 131
Pulse Off On, 136
Pulse Period, 133
Pulse Rate, 132
Pulse Width, 134
Square, 135
Triggered, 135
Triggered Doublet, 135
Pulse Period Increment, 134
Pulse Period softkey, 133
Pulse Rate softkey, pulse frequency, 132
Pulse Width softkey, 134
Pulse/RF blanking, 150
pulse/RF blanking markers
dual ARB subsystem, 150
Q
Q Offset softkey, 27
Quadrature Angle Adjustment softkey, 28
Quadrature Skew softkey, 29
queries
operation complete
*OPC, 76
options
*OPT?, 76
power- on status clear
*PSC, 76
read status byte
*STB?, 78
service request enable
*SRE?, 78
standard event status enable
*ESE?, 74
standard event status register
*ESR?, 75
querying
data questionable calibration event register, 95
data questionable calibration register, 94
data questionable condition register, 95
data questionable event register, 99
data questionable frequency condition register, 96
data questionable frequency event register, 97
data questionable power condition register, 97
data questionable power event register, 98
standard operation event register, 93
standard operation status group, 92
querying, signal generator capabilities, 100
quotes, SCPI command use of, 15
R
ramp sweep
range, 38
span, 38
real response data, 10
Real- time AWGN Off On, 140
Real- time AWGN Off On subsystem keys
Real-time AWGN Off On, 140
Real- time Noise softkey, 152
RECALL Reg softkey, 76
Ref Oscillator Ext Bandwidth softkey, 40
Ref Oscillator Ext Freq softkey, 40
Ref Oscillator Source Auto Off On softkey, 41
reference oscillator source, 41
references, xv
registers, presetting, 93