Agri-Fab MOW-N-VAC 501887 User Manual (English)

Questions and Answers:

D
dbushAug 11, 2025
Why is my Agri-Fab MOW-N-VAC 501887 Engine losing power and running erratically?
- C
  Christina SmithAug 11, 2025
  If your Agri-Fab Engine loses power or operates erratically, there are several potential causes. First, check the spark plug wire to ensure it is properly connected and tightened. If the unit is running on CHOKE, move the choke lever to the OFF position. A blocked fuel line or stale fuel can also cause issues, so clean the fuel line and refill the tank with fresh gasoline. Additionally, water or dirt in the fuel system can be a culprit; disconnect the fuel line at the carburetor to drain the fuel tank and then refill with fresh fuel. Other possible causes include a carburetor that needs adjustment or a dirty air cleaner that requires servicing.
K
kelleralexisAug 17, 2025
How to fix Agri-Fab MOW-N-VAC 501887 that fails to start?
- R
  roy83Aug 17, 2025
  If your Agri-Fab Engine fails to start, begin by checking the spark plug wire and ensure it's securely connected. Verify that the safety switch is properly engaged. Make sure the fuel tank isn't empty and contains clean, fresh fuel. If your engine has a fuel shut-off valve, ensure it is open. Finally, inspect the spark plug itself; it may need cleaning, gap adjustment, or replacement.
K
Kristen EllisAug 23, 2025
Why is my Agri-Fab Engine overheating?
- K
  Keith ReyesAug 23, 2025
  If your Agri-Fab Engine is overheating, it could be due to a carburetor that is not adjusted properly, so you should adjust it. Also, check the engine oil level and fill the crankcase with the proper oil if it is low.
C
carolinebondAug 29, 2025
What to do if my Agri-Fab MOW-N-VAC 501887 unit does not discharge?
- J
  jacksonkristenAug 29, 2025
  If the Agri-Fab Engine unit does not discharge, the discharge chute (elbow) might be clogged. Stop the engine immediately, disconnect the spark plug wire, and clean the inside of the housing and discharge chute (elbow). Alternatively, a foreign object might be lodged in the impeller; in this case, stop the engine immediately, disconnect the spark plug wire, and remove the lodged object. Lastly, if you are using a Mow-N-Vac cart, check if it is full and empty it if necessary.
D
Debra MillerSep 4, 2025
Why is there too much vibration in my Agri-Fab MOW-N-VAC 501887?
- T
  Troy ReillySep 4, 2025
  If there is too much vibration in your Agri-Fab Engine, stop the engine immediately, and disconnect the spark plug wire. Then, tighten all bolts and nuts. Make all necessary repairs. If vibration continues, have unit serviced by an authorized service dealer.

Agri-Fab MOW-N-VAC 501887 Specifications

General

Engine Brand	Briggs & Stratton
Engine Type	4-Cycle OHV
Displacement	205 cc
Starting System	Recoil
Fuel Type	Gasoline
Oil Type	SAE 30

Agri-Fab MOW-N-VAC 501887 User Manual

Table of Contents

Questions and Answers:

Agri-Fab MOW-N-VAC 501887 Specifications