操作说明
Operator Instruction
故障现
Fault
故障原因
Fault reasons
排除方法
Troubleshooting
1 前轮胎磨损严
重
Front
wheel
tyre(s) worn
seriously
(1) )球销、油缸、转向摆臂紧固螺母、
螺栓松动
Front wheel rim or spoke severely
deformed.
(2) 前束调整不当
Toe-in of front wheel is abnormal
(3) 轴承间隙过大或磨损严重
Steering knuckle and two pin shafts
of oil tank worn seriously
(4) 转向主销磨损严重
Tyre pressure not adequate during
transportation.
(5) 前轮轮辋严重变形
Front axle does not release before
transportation
(6) 驱动轮装反
Drive tyre thread mounted in reverse
(1) 校正前轮轮辋或辐板
Calibrate front wheel rim or spoke
(2) 调整前束
Adjsut toe-in
(3) 更换销轴
Replace axis pin
(4) 检查，并按规定对轮胎充气
Check and fill tyre with air according to
requirement.
(5) 脱开前驱动桥
Disconnect front drive axle
(6) 按要求重新安装轮胎
Refit the wheel according to the
requirements
2 前轮摆动
Front
wheel
swings
(1) 球销、油缸、转向摆臂紧固螺母、 (1) 检查紧固
螺栓松动
Check for the tightening
Set nuts or bolts for ball pin, oil
cylinder and steering arm are loose
(2) 前束调整不当 (2) 调整前束
Toe-in of front wheel is abnormal Adjsut toe-in
(3) 轴承间隙过大或磨损严重 (3) 调整或更换轴承
Bearing gap too large or severely Adjust or replace bearing
worn
(4) 转向主销磨损严重 (4) 更换转向主销
Knuckle pin severely worn Replace knuckle pin
(5) 前轮轮辋严重变形 (5) 校正前轮轮辋
Front wheel rim severely deformed Calibricate front wheel rim
To Next Page
Loading...
