操作说明
Operator Instruction
故障现象
Fault
故障原因
Fault reasons
排除方法
Troubleshooting
1 漏油
Oil leaking
(1) 各管道接头处胶圈损坏或螺栓松动 (1) 更换胶圈或拧紧螺栓
Rubber rings or bolts at various pipe joints Replace the rubber ring or
damaged or loose tighten the bolt
(2) 液压转向器阀体、隔盘、定子及后盖 (2) 清洗更换胶圈
结合面胶圈损坏
Wash and change rubber ring
Rubber rings on connections of hydraulic
steering gear valve body, separate
chamber, stator and rear cover damaged.
(3) 轴颈处胶圈损坏 (3) 更换胶圈
Rubber ring at axle journal damaged Replace rubber rings
(4) 转向器结合部位螺栓松动 (4) 拧紧螺栓
Bolts at joining portion of the steering Tightening bolts
gearloose
To Next Page
Loading...
